My Speedo Ver. 2
£108.18
This speedo module with touchscreen could be loaded with your own pictures and designs and you create an individual look for your bike. Your own picture would appear for 3 seconds at the display when you switch on the ignition. The control unit is connected with 4 cables to the LCD module.
Available on back-order
Description
Description
This speedo module with touchscreen could be loaded with your own pictures and designs and you create an individual look for your bike. Your own picture would appear for 3 seconds at the display when you switch on the ignition. The control unit is connected with 4 cables to the LCD module.
You´ll see a sample design at:
https://www.youtube.com/watch?v=MZKAChw5GJ4
Another example of the design is made from Robert Stiehler:
https://www.youtube.com/watch?v=tB67J9Fxmh8
The LCD is a Nextion 2,4″ touchscreen. The setup with your own pictures is easy like a normal picture editor. You should be able to implement your own pics on the display after 2 – 3 hours reading and playing with the display editor. Just feel free to follow the next 7 steps:
- Download and install the Nextion Editor from the website https://www.itead.cc/wiki/Nextion_HMI_Solution
- Just feel free to download and use the sample 1or sample 2as start file for your own design.
- Please us the id´s and names what are indicated in this table. These id´s are used in the controller unit.
- You´ll need to have a micro SD card with minimum 1 GB memory (Ebay, 1,-) and to format it in FAT32 format.
- Edit your own jpg pics with any kind of picture editor software. Please take care that the pictures will fit within the maximum LCD size what is 320 x 240 pixel. Load your pics in the Nextion editor and put it to the required position. Please take care that your picture have the same ID number like in the sample software below.
- Compile the software and copy it on the SD card.
- Put the SD card in the slot of the LCD and power up the speedo with 12 Volt. Wait until the LCD have successfully load the software. Remove the SD card.
That’s it. Now you have your own personal speedo 🙂
Feel free to download the speedo software from the Axel Joost website and start again if you have any issues with your first own software. However, you can send us your own pictures and ideas and the Axel Joost team can finish the LCD design for you.
Please note that you´ll need to take care that the LCD display is not water resistant and you´ll need to take care to implement it in a housing like in the following sample from Kustomkommune in Australia below:
| Dimensions control module: | 75 mm x 43 mm x 12 mm |
| Housing: | Must be solved from customer |
| Input voltage range: | 7 – 18 Volt |
| Connections: | Inputs 0,14 mm², 20 cm |
| Maximum ambience temperature: | 80 degree Celsius |
Additional information
Additional information
| Weight | .25 kg |
|---|---|
| Dimensions | 10 × 12 × 8 cm |
